User Manual

14
CONTROL STICK
Up-down and side-to-side movement
of the camera can be controlled by the
control stick in both Follow and Lock
modes.
Note: When in inverted mode, the
control stick will also be inverted, and
the platform will move opposite to the
control stick commands.
RECALIBRATING THE GIMBAL
1. Stand the WISP-20M on a flat
surface. Press and hold the control
stick for 2 seconds to stop the
motors.
2. Press and hold the control stick for
an additional 2 seconds to complete
the recalibration process. After 4 to 5
seconds, the WISP-20M will beep and
recalibrate. When it comes to a stop,
it is ready to use.
BATTERY STATUS LIGHT
The battery status light is located on the
handle, underneath the control stick.
• A green light indicates fully
charged batteries and normal
operation.
• A red light indicates low batteries.
• A blinking red light indicates
that the batteries need to be
recharged before further use.