User Manual

11
THE CAMERA WON’T FIT
OR BALANCE
Some cameras won’t fit properly on
the WISP due to the position of their
mounting sockets. The included adapter
plate can remedy this problem. Follow
these steps:
1. Loosen the tension screw and
remove the quick-release plate.
2. Insert the mounting screw into the
adapter plate from underneath.
3. Screw the adapter plate onto the
bottom of the quick-release plate.
Make sure the holes are along the
direction that gives you the best fit.
4. Make sure the adapter plate and
quick-release plate are secure.
Reseat the quick-release plate with
the camera/adapter assembly, and
tighten the tension screw.
Note: When attaching the adapter plate,
make sure the mounting screw is in the
middle of the quick-release plate. This
will make it possible to slightly adjust the
quick-release plate from side to side.
5. Continue to adjust the position of
the camera until it balances on the
mounting platform by itself.