CS-CPS-20a QU I C K -STA RT GUIDE
PRECAUTIONS • Please read and follow these instructions, and keep this manual in a safe place. • Keep this product away from children. • Make sure everything is secure before proceeding. • Make sure that this product is intact and that there are no missing parts. • To avoid damage to this product, be careful not to overtighten or improperly thread any of the threaded fittings. • Do not exceed the maximum load capacity. • Be careful not to catch your fingers in any of the moving parts.
G E T T I N G S TA R T E D Place the CS-CPS-20a Expanding Caterpillar Slider on a steady surface. When used on its feet, e.g., on the ground or a table, the CS-CPS-20a offers 18″ of sliding. You can adjust the length of the feet to prevent the slider from wobbling and fine-tune the position of the slider. To extend the foot, rotate it clockwise. To retract the foot, rotate it counterclockwise. (Fig. 1) Tip: Use the onboard bubble level to determine whether your shot is aligned with the horizon.
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig.
MOUNTING YOUR C AMER A / TRIPOD HE AD TO THE SLIDER Important! Before mounting your camera, lock down the camera base by tightening the brake. The camera base’s 1/4″-20 mount comes with the included 3/8″-16 bushing preinstalled. If your tripod head has a 1/4″-20 socket, remove the 3/8″-16 bushing from the mount before attaching your tripod head. To mount a camera or tripod head, follow these steps: 1. Loosen the mounting plate locks and remove the top mounting plate from the camera base. (Fig. 4) 2.
ONE-YEAR LIMITED WARRANTY This Axler product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
