Tus neeg siv phau ntawv

Installationsanleitung AXIbox 11K
EN221129 5
4 Operation
4.1 Operation with Acces restriction
In this operating mode, the wallbox is locked against unauthorised use. Authentication with one of the
supplied RFID cards or control via App is required for operation.
4.1.1 Starting the charging process with RFID-Card
1. Connect the wallbox to the car to be charged via the cable. Make sure that the cable is completely
unwound. The LED flashes yellow every 1 second.
2. Unlock the wallbox by holding the RFID card at the point marked "CARD" on the housing of the
AXIbox.
3. The charging process starts. During the charging process, the LED flashes green every 1 second.
4.1.2 Ending the charging process
1. Stop the charging process with the RFID card. When the car is fully charged, charging will stop.
2. Disconnect the charging plug from the vehicle and stow it at the wallbox.
4.1.3 Control via App
The AXIbox can be controlled via the Chargein app. The charging process can be started and stopped, and a
charging schedule can be created. The variation of the charging current is also possible via the app. The
RFID cards can also be integrated into the app and additional users can be activated. Illustrated instructions
for connecting to the app are enclosed with the unit (Charger Network Configuration).
If charging is started via App, the charging process must also be stopped with the App. If charging is started
with the RFID card, the charging process must also be stopped with the RFID card. When the car is fully
charged, charging will stop automatically.
Installation and Sign in
• Download the Chargein App
• Create an account
• Sign in to your account
Connect with the AXIbox 11K
• Requirements: 2,4 GHz W-LAN; Bluetooth, W-LAN and location must be activated at the
smartphone
• Select your Charger under User / Charger Management / Add Charger and confirm the serial
number.
Note: The charger must be shown automatically via Bluetooth, so that it only needs to be
selected. Entering the serial number manually or scanning the barcode will not work.
• Connect to your W-LAN
• After 10 to 60s, the AXIbox should be online, in the main menu it should show “In Standby”.
• Now, the charger can be controlled with the App.
ATTENTION: Do not activate Load Balance!