User`s guide

Page 10 AXIS T92E05/T92E20 User’s Guide
5. Install the cable cover and tighten the cable cover screws.
6. Connect the camera to the network. Depending on the type of housing, connect the network
cable to the network connector on the camera or the housing, see illustrations on page 9 and
page 10.
7. If applicable, check that the Status LEDs indicate the correct conditions. See table on page 12
for further details. Note that the Status LED can be configured to be unlit during normal
operation.
8. Loosen the bracket adjustment screw to aim the camera to the point of interest and focus the
camera according to the instructions in the Installation Guide provided with the camera.
9. Take the top cover and attach the safety wire to the tab on the bottom cover.
Network cables
I/O cable
Example image: AXIS P1343 Network Camera and AXIS T92E20 Outdoor Housing
Cable cover
Cable cover screw (2x)
Cable holes
Bottom cover
Wall bracket
Bracket adapter screw (4x)
Bracket adjustment screw
Cable holes
Network connector (PoE IN)
Alarm output
Cold Startup Delay switch
LED indicator
(see text below)
Network connector (PoE OUT)
Bottom cover
Example image: AXIS T92E20 Outdoor Housing