User`s manual

Chapter 4 Serial Communications AX2200/AX2300 Instruction Manual
4-24 CM2-AX2000-2001 (Rev. 4, 4/2014)
12. Change the required settings and press Exit & Enter buttons to save
theconfiguration
13. Dostepsfrombtog,andchangethecomm.TypeasHart.
14. Rebootthedevicebypoweroffandon.

Note:
a. IUTsupport9600,19200,38400baudrates
b. MACaddressrangeis0‐127
3. SupportedBACnetObjects
A BACnet object represents physical or virtual equipment
information, as a digital input or parameters. The AX2000 Vortex
Mass Flow Meters presents the following object types:
a. DeviceObject
b. AnalogInput
c. BinaryInput
d. BinaryValue
Each object type defines a data structure composed by properties
that allow the access to the object information. The below table
shows the implemented properties for each Vortex Mass Flow
Meters object type.

Properties ObjectTypes

 Device AnalogInput BinaryInput Binary
Value
Object_Identifier
   
Object_Name
   
Object_Type
   
System_Status



Vendor_Name



Vendor_Identifier



Model_Name


Firmware_Revision


Application‐Software‐Version


Protocol_Version


Protocol_Revision



Protocol_Services_Supported


