User`s manual
AX2200/AX2300 Instruction Manual Chapter 1 Introduction
CM2-AX2200-2001 (Rev. 4, 4/2014) 1-1
Chapter 1 Introduction
AX2000Series Multi-Parameter Vortex Mass Flow Meters
The azbilAX2200 In-Line and the AX2300 Insertion Vortex Flow Me-
ters provide a reliable solution for process flow measurement. From a
single entry point in the pipeline, AX2000Series meters offer precise
measurements of mass or volumetric flow rates.
Multi-Parameter Mass Flow Meters
Mass flow meters utilize three primary sensing elements: a vortex shed-
ding velocity sensor, an RTD temperature sensor, and a solid state pres-
sure sensor to measure the mass flow rate of gases, liquids, and steam.
Meters are available as loop powered devices or with up to three 4-20
mA analog output signals for monitoring your choice of the five process
variables (mass flow, volumetric flow, temperature, pressure and fluid
density). The Energy Monitoring option permits real-time calculation of
energy consumption for a facility or process.
Volumetric Flow Meters
The primary sensing element of a volumetric flow meter is a vortex
shedding velocity sensor. Meters are loop powered. The analog 4-20
mA output signal offers your choice of volumetric or mass flow rate.
Mass flow rate is based on a constant value for fluid density stored in the
instrument’s memory.
Both the mass and volumetric flow meters can be ordered with a local
keypad/display which provides instantaneous flow rate, total, and process
parameters in engineering units. A pulse output signal for remote totali-
zation and MODBUS or HART communications are also available.
AX2000Series digital electronics allows for easy reconfiguration for
most gases, liquids and steam. The azbil AX2200 and AX2300 Meters’
simple installation combines with an easy-to-use interface that provides
quick set up, long term reliability and accurate mass flow measurement
over a wide range of flows, pressures and temperatures.
Using This Manual
This manual provides information needed to install and operate both the
AX2200 Model In-Line and AX2300 Model Insertion Flow Meters.
Chapter 1 includes the introduction and product description
Chapter 2 provides information needed for installation
Chapter 3 describes system operation and programming
Chapter 4 provides information on HART and MODBUS protocols
Chapter 5 covers troubleshooting and repair
Appendix A - Product Specifications, Appendix B – Approvals,
Appendix C – Flow Meter Calculations, Appendix D – Glossary of
Terms