User`s manual

AX2200/AX2300 Instruction Manual Chapter 3 Operation
CM2-AX2000-2001 (Rev. 4, 4/2014) 3-17
If the meter display indicates a temperature or pressure fault, a substitute value can be entered to
allow flow calculations to continue at a fixed value until the source of the fault is identified and
corrected. The units of measure of the displayed values are the same as the units configured
for the flow meter.
Calibration Menu
The Calibration Menu contains the calibration coefficients for the flow meter. These values
should by changed only by properly trained personnel. The Vortex Coef Ck and Low Flow Cutoff
are set at the factory. Consult the factory for help with these settings if the meter is showing
erratic flow rate.