User`s manual

AX2200/AX2300 Instruction Manual Chapter 3 Operation
CM2-AX2000-2001 (Rev. 4, 4/2014) 3-9
Alarms Menu
Example for Setting an Alarm
The following shows how to set Relay Alarm 1 to activate if the mass flow rate is greater than 100 lb/hr. You can
check the alarm configuration in the Run Mode by pressing the  keys until Alarm [1] appears. The lower line
displays the mass flow rate at which the alarm activates. Note: all outputs are disabled while using the Setup Menus.
First, set the desired units of measurement:
1. Use  keys to move to the Units Menu (see to page 3-12).
2. Press  key until Mass Flow Unit appears. Press
ENTER.
3. Press  key until lb appears in the numerator. Press  key to move the underline cursor to the
denominator. Press the  key until hr appears in the denominator. Press
ENTER to select.
4. Press  key until Units Menu appears.
Second, set the alarm:
1. Use  keys to move to the Alarms Menu.
2. Press the  key until Relay Alarm 1 appears.
3. Press  key to access Measure selections. Press
ENTER and use the  key to select Mass. Press ENTER.
4. Press  key to select the alarm Mode. Press
ENTER and use  key to select HIGH Alarm. Press ENTER.
5. Press  key to select the value that must be exceeded before the alarm activates. Press
ENTER and use
 keys to set 100 or 100.0. Press
ENTER.
6. Press the
EXIT key to save your changes. (Alarm changes are always permanently saved.)
(Up to three relay alarm outputs are available depending on meter configuration.)