User`s manual
AX2200/AX2300 Instruction Manual Chapter 3 Operation
CM2-AX2000-2001 (Rev. 4, 4/2014) 3-1
Chapter 3 Operating Instructions
After installing the AX2000Series Vortex Flow Meter, you are
ready to begin operation. The sections in this chapter explain the
display/keypad commands, meter start-up and programming. The
meter is ready to operate at start up without any special pro-
gramming. To enter parameters and system settings unique to
your operation, see the following pages for instructions on using
the setup menus.
Flow Meter Display/Keypad
The flow meter’s digital electronics allow you to set, adjust and
monitor system parameters and performance. A full range of
commands are available through the display/keypad. The LCD
display gives 2 x 16 characters for flow monitoring and pro-
gramming. The six push-buttons can be operated with the enclo-
sure cover removed. Or, the explosion-proof cover can remain
in place and the keypad operated with a hand-held magnet posi-
tioned at the side of the enclosure as shown in the illustration at
the left.
Figure 3-1. Flow Meter Display/Keypad
VorTek
Instruments,
LLC
Pro-V
TM