User`s manual

AX2200/AX2300 Instruction Manual Chapter 2 Installation
CM2-AX2000-2001 (Rev. 4, 4/2014) 2-19
Enclosure Adjustment (AX2200 Models Only)
Figure 2-13. Enclosure Viewing Adjustment
To avoid damage to the sensor wires, do not rotate the enclosure beyond
180-degrees from the original position. To adjust the enclosure:
1. Remove power to the flow meter.
2. Loosen the three set screws shown above. Rotate the display to the
desired position (maximum 180-degrees).
3. Tighten the three set screws. Restore power to the meter.