User`s manual

AX2200/AX2300 Instruction Manual Chapter 1 Introduction

CM2-AX2200-2001 (Rev. 4, 4/2014) 1-9

Line Size / Process Connections / Materials

The AX2200 In-line model is built for line sizes ½ through 4 inch wafer

or ½ through 8 inch flanged design using ANSI 150, 300, 600, PN16, 40,

or 64 class flanges.

The AX2300 Insertion model can be used in line sizes 2 inch and greater

and is built with a compression fitting or packing gland design using 2

inch NPT, or 2 inch flanged connections (ANSI 150, 300, 600, PN16, 40,

or 64 class flanges). The packing gland design can be ordered with a

permanent or removable retractor.

The AX2200 In-line model can be built with A105 carbon steel, 316L

stainless steel, or Hastelloy C-276. The AX2300 Insertion model can be

built with 316L stainless steel or Hastelloy C-276.

Flow Meter Electronics

AX2000Series Flow Meter electronics are available mounted directly to

the flow body, or remotely mounted. The electronics housing may be

used indoors or outdoors, including wet environments. Available input

power options are: DC loop powered (2-wire), DC powered, or AC pow-

ered. Three analog output signals are available for your choice of three

of the five process variables: mass flow rate, volumetric flow rate, tem-

perature, pressure or fluid density. A pulse output signal for remote to-

talization and MODBUS or HART communications are also available.

AX2000Series Flow Meters include a local 2 x 16 character LCD display

housed within the enclosure. Local operation and reconfiguration is ac-

complished using six pushbuttons operated via finger touch. For hazard-

ous locations, the six buttons can be operated with the electronics enclo-

sure sealed using a hand-held magnet, thereby not compromising the in-

tegrity of the hazardous location certification.

The electronics include nonvolatile memory that stores all configuration

information. The nonvolatile memory allows the flow meter to function

immediately upon power up, or after an interruption in power.

All

flowmeters are calibrated and configured for the customer’s flow

application.