Installation guide

AXIS Q1910/Q1910-E Installation Guide Page 17

ENGLISH

Unit connectors

Network - RJ-45 Ethernet connector. Supports PoE (Power over Ethernet, class 3). Using shielded

cables is recommended.

Audio in - 3.5mm input for a mono microphone, or a line-in mono signal (left channel is used from

a stereo signal).

Audio out - 3.5mm output for audio (line level), can be connected to a public address (PA) system

or an active speaker with a built-in amplifier. A pair of headphones can also be connected. A stereo

connector must be used for audio out.

RS-485/422 - two 2-pin terminal blocks for RS-485/422 serial interface used to control auxiliary

equipment, e.g. PTZ devices.

The RS-485/422 serial port can be configured in the following port modes:

• Bidirectional RS-485 half-duplex port for data transmission using

two wires, one combined RX/TX pair.

• Bidirectional RS-485 full-duplex port for data transmission using

four wires, one RX pair and one TX pair.

• Unidirectional RS-422 port for transmitting or receiving data using

two wires, RX- or TX pair.

• Bidirectional RS-422 full-duplex port for data transmission (point-to-point) using four

wires, one RX pair and one TX pair.

SDHC memory card slot - High capacity SD memory card used for local recording and removable

storage.

Power - 3-pin terminal block 8-20 VDC or 20-24 VAC

Function Pin Notes

RS 485/422TX(A) 1 TX pair for RS-422 and 4-wire RS-485

RS 485/422TX(B) 2

RS-485A alt RS-485/422RX(A) 3 RX pair for all modes (combined RX/TX for 2-wire RS-485)

RS-485B alt RS-485/422RX(B) 4

CAUTION! - Incorrect connection of the wires could cause damage to the camera.

321

RS-485/422

RX/TX TX