User Manual
AXIS M5525-E PTZ Network Camera
Setup
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create an action rule in the
camera’s web page.
Use audio to deter intruders
This example explains how to connect a speaker to the camera and set it up to play a warning message when the camera detects
motion in a restricted area.
Required hardware
• Active speaker with built-in amplier and connecting wires
NONO
NO
TICETICE
TICE
Make sure the camera is disconnected from power before making the connections. Reconnect to power after connecting the
wires.
Physical connection
1. Connect the audio wire from the speaker to the AUDIO OUT pin on the camera. See Product overview on page 3 .
2. Connect the grounding wire from the speaker to the GND AUDIO OUT pin on the camera. See Product overview on page 3 .
Add audio clip to the camera
1. Go to Settings > Audio > Output and click
to add your audio clip.
2. Click Add.
3. Select Upload under Add Audio Clip Options.
4. Browse to locate the audio clip and click Upload.
To trigger the camera to play the audio clip when it detects motion, create an action rule in the camera’s webpage.
How to direct the camera and open the lock to a gate when someone is nearby
This example explains how to direct the camera and open a gate when someone wants to enter during daytime. This is done by
connecting a PIR detector to the product’s input port and a switch relay to the product’s output port.
Required hardware
• Mounted PIR detector
• Switch relay connected to the gate lock, in this case the switch is normally closed (NC)
• Connecting wires
Physical connection
1. Connect the wires from the PIR detector to the input pin, see I/O connector on page 20.
2. Connect the wires from the switch to the output pin, see I/O connector on page 20
Congure I/O ports
You need to connect the switch relay to the camera in the camera’s webpage. First, congure the I/O ports:
Set the PIR detector to an input port
1. Go to System > I/O ports.
13