User`s guide

Installation Summary AXIS 200+ and 240 User’s Guide

Installation Summary

You install your camera server in these steps:

• Connecting the hardware

• Assigning an IP address

• Verifying the installation

• Configuring the camera server

• Adjusting the focus

Connecting the Hardware

Connecting the AXIS 200+ to a Mounting Assembly

Fasten the camera server to the supplied mounting assembly and

position it appropriately for your application.

Note:

The AXIS 200+ can be mounted on any standard mount.

Tip!

To make the camera stand smaller, remove the middle part of the

mounting assembly. The camera holder can now be attached

directly to the foot. See the illustration.

Caution!

Connecting Your Cameras to the AXIS 240

Connect the cameras to the AXIS 240 using the appropriate cables/connectors. The AXIS 240 can

service up to four coax/BNC cameras and one S-video camera.

It is possible to connect a Pan/Tilt device to the RS-232 Pan/Tilt port of the AXIS 240 for remote

adjustment of the camera position. The AXIS 240 can control one Pan/Tilt device at a time, or

several if they are daisy chained. Refer to the Pan/Tilt Control information provided in the User’s

Manual and/or your camera supplier’s documentation for further details on connecting the

cameras.

The CCD (charged coupled device) within the AXIS 200+ can become permanently damaged if the

camera lens is exposed to too much direct sunlight, or halogen light! If this is the case, please use an

Auto Iris Lens. See

Appendix B - Auto Iris

for more information.

If used outdoors or in extreme environments, the camera server must

be housed in an outdoor

casing. For more information, please refer to the camera sever product pages at http//www.axis.com/

http//www.axis.com/http//www.axis.com/

http//www.axis.com/