User`s manual

Section 5: Setting Up - IBM Mainframe AXIS 5470e User’s Manual

JES3 Initialization Below is sample JES3 statements for an TCP/IP attached AXIS 5470e.

In the example the JNAME=PRT1 has been used.

Note:

The following paragraphs describe the JES3 initialization statements

shown above, which are typical of the JES3 statements used with

PSF. For more detailed descriptions of all JES3 initialization

statements, refer to the JES3 initialization and tuning publication for

your operating system.

PRTnnnn Statement Explanation

PRMODE

Specifies the data-set processing modes supported for the printer. It lists all the PRMODE values that the

printer accepts. If the AXIS 5470e is connected to a PostScript printer, the correct setting is

PRMODE=(PAGE,LINE,).. This setting indicates that composed-page and line data sets can be

printed.

SEP

Enables job-header and job-trailer separator pages to be produced.

Note1: If the Distributed Print Function (DPF) of PSF/2 is installed, you may need to set

this parameter to

YES.

Note2: This parameter is new in JES2 and replaces the SEP | NOSEP parameter.

SEPDS

Enables formatted data-set header separator pages to be produced.

Note: This parameter is new in JES2 and replaces the SEPDS | NOSEPDS parameter.

START

Specifies the way that the printer is started. The parameter value NO specifies that the printer is to be started

by an operator command. The parameter value

YES specifies that the printer, if it is ready, is to start

automatically when JES2 starts processing.

Note: This parameter is new in JES2 and replaces the DRAIN | START parameter.

TRKCELL

Specifies whether track-cell despooling is to be used or not. It is recommended to set this parameter to YES.

UCS

Specifies a default font. If you want to select a font in the startup procedure instead of the JES2 default font,

you should set this parameter to

FSSDEF,TYPE=WTR,FSSNAME=FSS3,PNAME=SAMPPRO3,SYSTEM=SYS1,TERM=NO

DEVICE,DTYPE=PRTAFP1,JNAME=PRT1,JUNIT=(,SYS1,,ON),FSSNAME=FSS3

MODE=FSS,PM=(LINE,PAGE,),CHARS=(YES,GT12),

CARRIAGE=(TES,A868),CKPNTPG=100,HEADER=YES,WC=(C)

This is only an example. For specific coding for JES parameters, refer to the JES

publication for the level of JES you are using.