User`s manual

Section 5: Setting Up - IBM Mainframe AXIS 5470e User’s Manual

The following paragraphs describe the JES2 initialization statements

shown above, which are typical of the JES2 statements used with

PSF. For more detailed descriptions of all JES2 initialization

statements, refer to the JES2 initialization and tuning publication for

your operating system.

FSS Statement:

The

FSS initialization statement is optional but recommended. If it is

omitted, JES2 generates a default FSS for that device. The

FSS

initialization statement defines an FSS to JES2. The

FSS statement is

associated with one or more

PRTnnnn statements that define each

printer FSA. For a description of all FSS parameters, refer to the JES2

initialization and tuning publication for your operating system. The

FSS statement contains the following parameters for PSF:

PRTnnnn Statement:

PRTnnnn statement, which is required to define each printer nnnn

statement FSA, is associated with an

FSS statement. Each printer

FSA should have a unique

PRTnnnn name that must match the label

on the

CNTL, ENDCNTL, and PRINTDEV statements for the PSF startup

procedure specified in the

PROC parameter.

Note:

FSS Statement Explanation

FSS (fasname)

Specifies the unique 1- to 8-character name of a particular FSS. This name is referenced in the PRTnnnn

statement for each printer FSA that is associated with this FSS. When you start the first printer that has an FSA

definition for that FSS, an FSS address space is created for PSF. PSF manages this FSS and the printer FSA for

the first printer. If you start a second printer with an FSA definition for the same FSS, PSF manages a separate

FSA for the second printer in that FSS.

PROC

Specifies a procedure for starting the PSF FSS. The procedure, which must be defined before that FSS is started,

is a member of either SYS1.PROCLIB or a library concatenated to SYS1.PROCLIB.

HASPFSSM

Specifies the 1- to 8-character name of the load module that is loaded into the PSF FSS address space. This

load module contains the various FSI service routines that JES2 supplies. For PSF, specify the default value

(

HASPFSSM=HASPFSSM).

The label on the PRINTDEV statement must be 8 characters or fewer. PSF

accepts the PRTnnnn, PRINTnn, and PRINTERn formats. PRTnnnn is the

recommended format.