User`s manual
Section 4: Setting Up - AS/400 AXIS 5470e User’s Manual
40
Use the command WRKCFGSTS *CTL xxxx* (where xxxx is the
first 4 characters of the AXIS 5470e 5494 LU Name)and press
Enter to delete any previously created Controller and Device
descriptions specific to your AXIS 5470e. Delete the Device
Descriptions (indented text) first and then the Controllers. Print a test
page if you are unsure of the AXIS 5470e 5494 LU Name.
Configuring the
AXIS 5470e
To perform the instructions presented in this section, you should first
assign an IP address to your AXIS 5470e using one of the methods
presented in Assigning an IP address, on page 20.
After you have completed the procedures in the AS/400 Host system
checklist above, follow the instructions below to configure the AXIS
5470e for SNA printing in the AS/400 environment using a Web
browser:
1. Start a Web browser, e.g. Internet Explorer or Netscape
Navigator.
2. Enter the IP address or the host name of the AXIS 5470e in the
location field and press the Enter key on your keyboard. The
internal Web pages of the AXIS 5470e will appear.
Work with Configuration Status S1032BB0
Position to . . . . . Starting characters
Type options, press Enter.
1=Vary on 2=Vary off 5=Work with job 8=Work with description
9=Display mode status 13=Work with APPN status...
Opt Description Status -------------Job--------------
FSIOP ACTIVE
ETHERNET ACTIVE
AXIS11 ACTIVE
AXIS11 ACTIVE
AXIS11 ACTIVE/TARGET SHEILA QUSER 010190
AXIS11 ACTIVE/SOURCE SHEILA QUSER 010190
AXIS11 ACTIVE/SOURCE SHEILA QUSER 010190
AXIS11 ACTIVE/SOURCE SHEILA QUSER 010190