User`s manual

Section 13: Using Logical Printers AXIS 5470e User’s Manual
176
2. Select the PR2 tab.
3. Set the Printer Language Translation parameter to POSTSCR.
4. Click OK.
Note:
Debugging using the
Hex Dump Mode
When hex dump mode is activated, the print data is printed as
hexadecimal byte values rather than characters; printer control
commands are also printed as hex values. This allows you to inspect
the control and print characters that are being sent to the printer,
which is a useful debugging facility for the more difficult printing
problems.
Example: Follow the instructions below to activate the hex dump mode for
PR1:
1. Click admin and the Logical Printer Settings button.
2. Select the PR1 tab.
3. Set the Hex Dump Mode Enabled radio button to YES.
4. Click OK.
Note:
If you select the parameter value AUTO_PS, the print data for every print job is
searched and if any ASCII data is found, it is translated into PostScript. This
setting is recommended if you are not sure if the print data is ASCII or PostScript.
The page length for hex dump printouts is determined by the lines per page value
of the PostScript page format parameter.