User`s manual

Section 11: Management and Configuration AXIS 5470e User’s Manual
152
Using SNMP
You can use SNMP (Simple Network Management Protocol) for
remotely monitoring and configuring of the AXIS 5470e. All major
functions for print servers are supported.
General Information SNMP refers to a set of standards for network management,
including a protocol, a database structure specification, and a set of
data objects. The AXIS 5470e SNMP implementation runs in the
TCP/IP environment.
The management is handled by NMS (Network Management System)
software running on a host on your network. The NMS software
communicates with network devices by the means of messages,
which are references to one or more objects.
A message can be a question or an instruction to a device, or an
alarm triggered by a specific event in a device. Objects are contained
in data bases called MIBs (Management Information Base), where
MIB-II is a standard database.
The AXIS 5470e supports all relevant parts of MIB-II and also
includes a private enterprise MIB. Refer to The AXIS MIB, on page
153.
System Requirements
for SNMP
The following requirements must be fulfilled in order to make full use
of the AXIS 5470e SNMP support:
• NMS software that allows you to install private enterprise MIBs
• A host, supporting FTP, on which to run the NMS software
Follow these steps to add the AXIS MIB to your NMS software:
1. Log in to the AXIS 5470e using FTP.
2. Download the MIB file /snmp/axis.mib to the NMS host.
3. Install the AXIS MIB according to instructions in your NMS
software documentation.