User`s guide

AXIS 5470e User’s Guide 17
Notes for SCS printing:
Note for IPDS printing:
Verifying the Communication Link
1. Type WRKCFGSTS *CTL xxxx* on the AS/400 command line (xxxx equals the first
four characters of the AXIS 5470e LU Name). The following items are displayed:
• One APPC controller with the same name as the AXIS 5470e LU Name.
• One APPC device with the same name as the AXIS 5470e LU Name, one controlling
session (QRMTWSC) and the currently active (default = 1) printer
sessions(QRMTWSC).
• One twinax controller named xxxxxRMT, where xxxxx is the first five characters of
the AXIS 5470e LU Name.
• One twinax printer device named xxxxPRT0z where xxxx is the first four characters
of the AXIS 5470e LU Name and z is the printer device number.
The status of all items should now be ACTIVE or VARIED ON.
2. Type STRPRTWTR xxxxPRT0z on the AS/400 command line, where xxxxPRT0z is
the printer device name. This will start the writer for this printer device.
3. Direct a printout to this printer device to check the integrity of the communication link.
4. Press the AXIS 5470e test button once to print a test page. Ensure that the SNA status is
defined on the test page as Idle, Actv or LU-1
Note:
Proceed to Management and configuration on page 47 for information on supported
management and configuration tools.
• In the Configuration Wizard’s IBM Printer Emulation window, 38xx is the value used for LaserWriter
printers and all other values are used for matrix printers. For further information, see the AXIS 5470e
User’s Manual .
• In the Configuration Wizard Printer Driver window, PCL is used for LaserWriter printers, all other val-
ues apply to matrix printers.
In the Configuration Wizard, you can choose between PCL or PostScript printing. Choose the printer
language that corresponds to your printer.
If the setup fails, please refer to the troubleshooting section in the AXIS 5470e User’s Manual,
supplied on the Axis Web site at http://www.axis.com