User`s guide

AXIS 5470e User’s Guide 15
8. Type DSPSYSVAL QAUTOCFG and press Enter. Check that the parameter is set to
ON(1). Press F3.
9. Type DSPSYSVAL QAUTORMT and press Enter. Check that the parameter is set to
ON(1). Press F3.
10. Type DSPMODD QRMTWSC on the command line to check that the mode description
exists on the system. Press F3. Refer to the AXIS 5470e User’s Manual for information
regarding the QRMTWSC mode.
11. Type DSPUSRPRF QUSER. Make sure that the QUSER Status is *ENABLED and has
its Maximum Storage Allowed parameter set to *NOMAX. Press F3.
12. Use the command WRKCFGSTS *CTL xxxx*, where xxxx are the first 4 characters of
the AXIS 5470e LU Name, to delete any previously created Controller and Device
descriptions specific to your AXIS 5470e. Delete the Device Descriptions (indented text)
first and then the Controllers. (You will find the print server’s LU Name in the Parameter
List, under SNA menu. Press the print server’s test button twice to print the Parameter
List.)
If you experience problems with the installation procedure, please refer to the AXIS 5470e
User’s Manual which is available from the Axis Web site at http://www.axis.com