User`s manual

AXIS P1311 - Accessing the Camera

Adjust the image and focus with Focus Assistant

To focus the AXIS P1311 using the Focus Assistant follow the instructions

below.

1. Power-on the AXIS P1311 and wait for about a minute.

Mount or place the camera so that it cannot be moved. See the

notes below.

3. Set the camera to its extreme distant-focus position by loosening

the focus puller and turning the lens fully clockwise.

4. Press and quickly release the Control button. When the Status LED

flashes green, the Focus Assistant is enabled.

If the Status LED flashes either red or yellow before you are able to

adjust the lens, skip to step 7 to exit the Focus Assistant and repeat

steps 3 -7. See the notes below.

5. Gently turn the lens anti-clockwise until it stops. Do not force the

lens too far or it will separate from the camera.

6. Finally, turn the lens slowly clockwise until the status indictor

flashes green (not red or yellow).

7. To exit the Focus Assistant, press the control button again.

8. Retighten the focus puller.

9. Open the Live View page in your web browser and check the quality

of the image.

Notes:

• If the view in front of the camera changes during adjustment (if a

finger or other object is placed in front of the lens, or if the camera

is moved), steps 3 -7 will have to be repeated.

• If the control button is not released within two seconds, dynamic

DNS is enabled instead of the Focus Assistant.

Adjusting the back focus

The back focus of the AXIS P1311 is set at the factory and does not need

adjustment.

However, the back focus might need to be a

djusted when attaching a new

lens that has specifications that are different from the original lens.

Notes:

• Turning the screw clockwise moves the sensor away from the lens by

0.5 mm/r.

• Do not turn the screw beyond the end stop; it can damage the

camera.

Focus puller

Status indicator

Control

button

Back focus screw