User manual

AXIS M1144–L
System Options
3. The card can now be removed.
The SD card is managed on the System Options > Storage page. Click SD Card to o pen Storage M anagement.
If the card’s status shows as fa ile d, click Check disk to see if the problem can be found and then try Repair. T his option is only
available for S D card s with ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.
To avoid filling the ca rd, it is recommended to remove recordings continuously. Under Recording Settings, select Remove recordings
older than and select the number of days or weeks.
To stop writing to the card and protect recording s from being removed, select Lock under Recording Settings.
Network Share
Network share allow s you to add network storage such as a NAS (Network Attached Storage) or any server that uses C IFS (Common
Internet File System) and use them for storage of recordings.
To add a network share:
1. Go to System Options > Storage.
2. Click Network Share.
3. Enter the IP address, DNS or Bonjour name to the host server in the Host field.
4. Enter the name of the share in the Share fi el d.
5. If required, select The share requires login and enter the u se r name and password.
6. Click Connect.
To clear all recordings and data from the A xis product’s folder on the des
ignated share, click Clear under Storage Tools.
To avoid filling the share, it is recom m e nded to rem ove recordings
continuously. Under Recording Settings,selectRemove recordings
older than and select the number of days or weeks.
To stop w riting to the share and protect recordings from being removed, select Lock under Recording S ettings.
Ports & Devices
I/O Ports
The Axis product provides one input port and one output port for connection of exte rnal devices. For information on how to
connect external devices, see
Connectors on page 4 .
The I/O p orts are configured under System O ptions > Ports & Devices > I/O Ports. The ports can be given descriptive names and their
Normal st
ates can be configured as Open circuit or Grounded circuit.
Port Status
The list on the System Options > Ports & Devices > Port Status page shows the status of the product’s input and output ports.
Maintenance
The Axis product provides several maintenance functions. These are available under System Options > Maintenance.
Click Restart to perform a co rrect restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Click Restore to reset m ost settings to the factory defau lt values. The following settings a re not affected:
42