User manual
AXIS M1144–L
System Options
Note
The initial password can only be set once. If the p assword is lo st, the Axis prod uct must be reset to factory default, see
Reset to Factory Default Settings o n page 44
.
UPnP
TM
The Axis pro duct includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disable d under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are co nfig u red under System Options > Network > RTP.
The RTP port range defines the range of p o rts from which the video ports are automati ca lly selected. For multicas t streams, only
certain IP addresses and port numbers should be used.
Select Always Mu lticast Video to start multicast streamin g without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjo ur is enabled by default and the produ ct is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD card should always be unmounted before
it is ejected.
The Axis product supports SD cards with the fo llow ing file systems:
• ext4 — recom m e nde d due to its resilience against data loss if the card is ejected or if there is a brupt power loss. To access
data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.
• vFAT — most SD cards are pre-formatted with vFAT when purchased.
If required, the SD card can be re-formatted to the desired file system . To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage an d click SD Card.
3. Click Format and select the desired file system.
Note
During formatting any previous d ata stored on the disk wi ll be lost.
Mounting is done automatically when the card is inserted or whe n the product is started. A manual mount is only required if the
card has been unmounted and not ejected and re-inserted.
To unmount the SD card:
1. Go to System Options > Storage an d click SD Card.
2. Click Unmount.
41