User`s manual

Appendix A: The Parameter List
Axis AFP User’s Manual 73
#100 Maximum Page Length
Defines the Maximum Page Length (MPL) in number of lines.
Notes: 1. This parameter has only effect in non-IPDS modes.
2. In SCS mode, this setting may be overridden by a data stream Set Vertical
Format command.
3. If set to 0, or greater than the physical paper length, the MPL will default to
the maximum value possible.
4. This parameter emulates an IBM 3812/3816 front panel switch: Maximum
Page Length (MPL).
#101 Maximum Print Position
Defines the Maximum Print Position (MPP) which sets the width of the page in
number of characters.
Notes: 1. This parameter has only effect in non-IPDS modes.
2. If set to 0, or greater than the physical page width, the MPP will default to
the maximum value possible.
3. This parameter emulates an IBM 3812/3816 front panel switch: Maximum
Print Position (MPP).
Value
Description
0 - 999
MPL setting in number of lines.
* 66
Factory default value.
Value
Description
0 - 999
MPP value in number of characters.
* 132
Factory default value.