User`s manual

Section 6: Solving Problems
58 Axis AFP User’s Manual
Messages
Apart from showing messages with the indicators, as described in Appendix C, the
Axis AFP can also print the following messages:
Rotary switch position ‘1’ has been selected in Function Mode and parameters
have been set to factory defaults.
Rotary switch position ‘4’ has been selected in Function Mode and Hex Dump
Mode is started.
A too large font or too many fonts were down-loaded from the host. Add more
memory to the printer and adjust the PS VM Size parameter in Axis AFP accord-
ingly.
Invalid transparency data has been received (Coax mode only). See Section 4.2.
The printer has terminated the PostScript job in an uncontrolled manner. This
can be caused by an incorrect printer time-out setting, or a manual printer restart.
Make sure that the printer doesn‘t terminate the print job, or set an AFP/PS job
time-out, see Appendix A, parameter #3290.
FACTORY DEFAULT SET
IBM HEX DUMP MODE SET
TO EXIT, SELECT POSITION 9 OR POWER OFF
Printer Memory Overflow.
Unable to load font to PostScript printer.
Using printer default font instead.
Following pages may be corrupted.
Service info:
InlSeq:
UniqueID:
HostID:
VMSize:
HEX TRANSPARENCY ERROR.
Following pages may be corrupted.
WARNING!! AFP/PS Prologue is lost.
Check printer time-outs & restart AFP/PS.