User`s manual

Section 6: Solving Problems

56 Axis AFP User’s Manual

Error Report

If you run into problems that you can’t solve on your own, it is important that you

make an error report for your System Manager or local distributor. See also appen-

dix G, How to contact Axis, on page 141. The error report should include:

• A printout with a description of the inaccuracies that occur

• The PostScript printer presentation page or Power-on page (see Section 2.5)

• A Parameter List (see Section 6.3.1)

• A hex dump (see Section 6.3.2).

Printing the

Parameter List

The Parameter List shows the complete Axis AFP configuration. To print the Pa-

rameter List, do as follows:

1. Make sure that your printer is on-line.

2. Set the rotary switch to ‘9’, and wait for approx. 3 seconds until the STA-

TUS indicator starts to ﬂash. You are now in the Function Mode.

3. Select position ‘8’ to start the printout.

4. Set the rotary switch to ‘9’ when the printout is completed. The STATUS

indicator will stop ﬂashing.

5. For coax connections, select position ‘0’ to resume normal print operation.

For twinax connections select the current device address to resume normal

print operation.