User`s manual

Section 2: Installation
14 Axis AFP User’s Manual
Follow these steps to configure your AS/400:
1. Find a free Device Address using the
[PRTDEVADR] command.
2. Turn the Automatic Configuration on using the
[CHGSYSVAL QAUTOCFG '1'] command.
3. Connect the Axis AFP to the twinax line.
4. Power on the Axis AFP , and wait for approx. 5 seconds until the SYSTEM
indicator goes on.
5. Verify that the AS/400 has detected a new device by using the [WRK-
DEVD] command.
6. Disable the Automatic Configuration [CHGSYSVAL QAUTOCFG
'0'] .
7. Optionally, you may rename and describe the device. You can also enable
the OS/400 AFP Print Services by setting [AFP = *YES] , see previous
page. This is done using the [WRKDEVD] command.
8. Verify the configuration by making a hardcopy. If nothing is printed, use the
[WRKCFGSTS *DEV] , [WRKWTR], and [WRKSPLF] commands to find
the cause.
Vary off the printer before using the [WRKDEVD] command.