User`s manual

Section 2: Installation
12 Axis AFP User’s Manual
Select Coax or Twinax Connection
The Axis AFP must be configured for the correct IBM host connection before
starting the installation. The Axis AFP can be configured for IBM 3270/Coax or
IBM 5250/Twinax connection using a switch on the back panel (see figure below).
To select coax or twinax mode do as follows:
1. Make sure that the Axis AFP is disconnected from the power supply and
the system.
2. Slide the back panel switch to COAX or TWINAX
3. To reconnect the Axis AFP, follow instructions in “Printer and System
Attachment” on page 15.
System Configuration, coax mode
Coax: The Axis AFP emulates the IBM 4028/3916/3812/3816/3112/3116 Group 4
IPDS page printers. Configure the system as if you were installing one of these
printers. When PSF is used, it must be configured according to the resolution (240
or 300 dpi) of the emulated printer.
Coax/Twinax Mode Switch
0
1
2
3
4
5
6
7
8
9
PS-BPRINTER / PC SHARESYSTEMCOAX
TWINAX