User`s manual

Appendix A: The Parameter List
Axis AFP User’s Manual 113
#3013 PS Restart at Duplex
Use this parameter to terminate the current print job and start a new each time a
simplex-to-duplex transition occurs. This function may be required for older ver-
sions of certain printers.
#3014 Optimize Duplex
Use this parameter to optimize duplex print jobs. Optimization means that sheets
are printed in simplex if the back side is empty resulting in higher throughput.
However, some printers will internally turn the sheet upside down when duplex is
used. This may cause undesired effects when using preprinted forms. Seting this
parameter to No will force the entire job to be printed in duplex mode.
#3015 Job Separation
IBM host systems configured to separate IPDS print jobs do this by sending a sep-
arator command (XOH:DGB) between jobs. This parameter controls whether the
Axis AFP should terminate the current print job when a XOH:DGB command is
received.
Related parameters: #3290 Job Time-out
#3292 Job End String
Value
Description
* No
Do not restart the print job at simplex-to-duplex transition. (default)
Ye s
Restart the print job at simplex-to-duplex transition.
Value
Description
No
Use duplex mode for all sheets.
* Ye s
Use simplex mode for single-sided sheets. (default)
Value
Description
No
Ignore all XOH:DGB commands.
* Ye s
Terminate current print job at XOH:DGB command. (default)