User`s manual

Section 6: Setting Up - OS/2
AXIS 570/670 MIO User’s Manual 93
OS/2
Section 6 Setting Up - OS/2
This section describes how to set up your AXIS 570/670 MIO for
printing in the OS/2 environment, after it has been connect to your
network.
If you intend to operate your AXIS 570/670 MIO in a multiprotocol
environment, you should also proceed to the other relevant sections in
this manual, namely:
Section 3 Setting Up - SNA
Section 4 Setting Up - NetWare
Section 5 Setting Up - Windows
Section 7 Setting Up - Macintosh
Section 8 Setting Up - UNIX
Section 9 Web Based Management
Installation Using AXIS Print Utility for OS/2
The installation and setup operations are performed with the AXIS
Print Utility for OS/2. You should install this utility now if you have
not already done so - see the instructions on the OS/2 Utilities disk
label.
Should you require to change the default name of your
AXIS 570/670 MIO or amend any of default parameters use the AXIS
NetPilot™ from any Windows platform that is connected to your
network, or WinOS/2 window under OS/2.
The AXIS Print Utility for OS/2 is not needed on the client platforms
when using a client-server configuration.
SNA