User`s manual

Section 5: Setting Up - Windows
AXIS 570/670 MIO User’s Manual 81
Windows
Section 5 Setting Up - Windows
This section describes how to set up your AXIS 570/670 MIO for
printing in the Windows environment, after it has been connected to
your network.
The following Windows platforms are supported:
• Windows 3.1 (requires add-on network support, see page 83)
• Windows for Workgroups
• Windows 95
• Windows NT
If you intend to use the AXIS 570/670 MIO in a multiprotocol
environment, you should also proceed to other relevant sections in this
manual, namely:
Section 3 Setting Up - SNA
Section 4 Setting Up - NetWare
Section 6 Setting Up - OS/2
Section 7 Setting Up - Macintosh
Section 8 Setting Up - UNIX
Section 9 Web Based Management
Installation Using AXIS Print Utility for Windows
Unless you wish to change the default name of your
AXIS 570/670 MIO, the setup operation may be performed solely
with the AXIS Print Utility for Windows, which is supplied on the
AXIS Utilities disk. You should install this utility now if you have not
already done so - see the instructions on the AXIS Utilities disk label.
If you wish, you may change the default name of your
AXIS 570/670 MIO or amend any of the default parameters, using the
AXIS NetPilot™, or any standard Web browser. Refer to Section 9 -
Web Based Management.
SNA