User`s manual

Section 3: Setting Up - SNA
AXIS 570/670 MIO User’s Manual 47
SNA
Controller and
Device Names
The names of the controllers and devices created in the AS/400 during
autoconfiguration are by default the last 7 digits from the
570/670 MIO serial number in reverse order, preceded by the letter
“A”. For example, serial number “00408C180102” will result in
APPC-controller “A201081C”, APPC-device “A201081C” and
RWS-controller “A2010RMT”. Printer devices will be named
“A201PRT01”, “A201PRT02”, “A201PRT02”… The designation
“PRTnn” corresponds to the logical printers in the Print Server, i.e.
printer device “A201PRT01” will be mapped to Logical Printer #1.
By default, all Logical Printers are mapped to the Physical Port MIO.
Changing Parameters
after
Autoconfiguration
If you want to change some of the critical configuration parameters
after autoconfiguration is completed, you should first set AUTODIAL
to NO, then remove all descriptions in the AS/400, and then change
the parameter(s) and set AUTODIAL to YES to initiate a new
configuration process.
Proceed to the AXIS 570/670 MIO Set-up, on page 61 to customize the
Print Server.
Manual Set-up
In OS/400 versions earlier than Version 3 Release 1, RWS controller
and printer devices cannot be created automatically and will therefore
need to be established manually.
Before attempting manual configuration, make sure that the SYSVAL
QAUTOCFG parameter is enabled. Also make sure the user QUSER
has enough memory space allocated. *NOMAX is recommended.
Setting Parameters
Prior to configuration, the following Parameters must be correctly set
in the Print Server:
• DEVICE_EMUL must be set to 5494
• H1_ADDR must be set to the MAC address of the host
• H1_LU_NAME must be set to the host system LU name
• H1_NW_NAME must be set to the host system Network Name
• Set AUTODIAL no NO
These parameters are discussed in
AXIS 570/670 MIO Set-up,
on page 61.