User`s manual

Section 3: Setting Up - SNA
AXIS 570/670 MIO User’s Manual 37
SNA
Section 3 Setting Up - SNA
Installation in the SNA environment
Preparing for
Installation
The basic installation in the SNA environment consists of two parts:
• Setting up the AXIS 570/670 MIO for SNA printing
• Setting up the host for communication with the AXIS 570/670
MIO.
Setting up the AXIS 570/670 MIO is preferably done using the AXIS
NetPilot™, which requires a computer running Windows connected
to your LAN. To install your network print server using the
Installation Wizard in AXIS NetPilot™ refer to Section 2 - Basic
Installation.
Alternatively, you can do the setting up using HTTP from a Web
browser, or FTP. Once the basic communication parameters are set and
a communication link to the host is active, Extended Emulation may
be used as yet another set-up alternative.
If you do not have any computers running Windows and NetWare or
NetBIOS/NetBEUI you can use the printer’s Front Panel to make the
necessary SNA configuration. See page 135.
If you intend to operate your AXIS 570/670 MIO in a multi-protocol
environment, you should also proceed according to one or more of the
following sections, as appropriate to your network.
Section 4 Setting Up - NetWare
Section 5 Setting Up - Windows
Section 6 Setting Up - OS/2
Section 7 Setting Up - Macintosh
Section 8 Setting Up - UNIX
Section 9 Web Based Management
SNA