User`s manual

Section 2: Basic Installation
20 AXIS 570/670 MIO User’s Manual
Basic Set Up of the Network
Installation Guide
After connecting the AXIS 570/670 MIO to your network you are now
ready to perform the basic setup procedures. The method of
installation that you choose should be dictated by your printing
requirement and the type of network into which you are integrating.
Proceed with an appropriate installation method from the list below:
IBM
• To use the AXIS 570/670 MIO with an IBM mainframe or
midrange system, you have to configure your IBM host and the
AXIS 570/670 MIO in accordance with:
- Basic Set Up with AXIS NetPilot. Then proceed to:
- Section 3 Setting Up - SNA.
Windows
• If you have access to a Windows platform which uses NetWare you
should firstly follow the procedures defined in:
- Basic Set Up with AXIS NetPilot. Then proceed to:
- Section 4 Setting Up - NetWare
UNIX
• Perform the basic TCP/IP set up procedures if your network uses
UNIX workstations, as defined in:
- Basic Set Up for TCP/IP. Refer then to:
- Section 8 Setting Up - UNIX
Windows
• If your Windows platform uses NetBIOS/NetBEUI, use the AXIS
NetPilot™ only if you want to change the default print server
name. If this is unnecessary, proceed directly to:
- Section 5 Setting Up - Windows
If your Windows platform does not use either NetWare or
NetBEUI, you must initially perform the basic TCP/IP set up
procedures, as defined in:
- Basic Set Up for TCP/IP. Refer then to:
- Windows NT LPD Printing, Section 5
OS/2
• If your network uses OS/2 workstations, use the AXIS NetPilot™
only if you want to change the default print server name. If this is
unnecessary, proceed directly to:
- Section 6 Setting Up - OS/2