User`s manual

Section 2: Basic Installation
18 AXIS 570/670 MIO User’s Manual
Test the Connection:
1. Switch on the printer.
2. Press and release the test button on the AXIS 570/670 MIO to
print a test page.
The test page shows the most important parameters and the firmware
version number. At this stage all that matters is whether the test page
has printed satisfactorily.
Connecting the AXIS 570 MIO to the Ethernet Network
1. Switch off the printer.
2. Connect a twisted pair (10baseT) or thin wire (10base2) cable to
the AXIS 570 MIO.
3. Switch on the printer.
4. Successful connection of ther AXIS 570 MIO to your netwoerk
will be confirmed by the intermittent flashing of the Network
Indicator.
5. You are now ready to install your server onto your network using
one of the methods detailed in the Installation Guide, on page 20.
By commencing with your preferred installation method, you can
further verify that your AXIS 570 MIO is properly connected to
your network.
Note:
❏ Each AXIS 570 MIO Printer Server is pre-configured with a
unique Node Address that is identical to the serial number. This
can be changed using the AXIS NetPilot™, the Front Panel of the
printer or any standard Web browser using HTTP, if required.
AXIS
570 MIO