User`s manual

Section 2: Basic Installation
16 AXIS 570/670 MIO User’s Manual
Installing the AXIS 570/670 MIO in the Printer
The AXIS 570/670 MIO board should be installed into the MIO
expansion slot at the rear of your HP printer. The guidelines below are
for the HP LaserJet 4+, but the installation procedure is similar for all
HP printers. If you have a printer other than the LaserJet 4+, consult
the printer manual on how to access the MIO slot.
Caution
The AXIS 570/670 MIO board contains static-sensitive components.
To prevent the risk of damage to these components, always hold the
board by the edges or the rear panel when removed from the anti-static
bag. Make sure to take all recommended precautions related to
static-sensitive devices.
You will need one posidrive and one flat screwdriver for the
installation.
Follow these steps and refer to the illustrations to install the AXIS
570/670 MIO board:
Removing the cover plate (HP LaserJet 4+)