User`s manual

Appendix B: The Parameter List
134 AXIS 570/670 MIO User’s Manual
4. Down-load the config file. Command:
put config CONFIG↵
Editing from a
Macintosh
If you are using an Apple EtherTalk system you will need MacTCP on
your computer, and an ftp utility (e.g. Fetch or Anarchie) to get access
to the config file from your Macintosh. Proceed as described above.
Editing from
an IBM host
Once communication with an IBM host has been established, all the
AXIS 570/670 MIO parameters can be edited by printing a file
containing special configuration commands. To start the
configuration, the command
%CONFIG+
is entered in the file. To
protect your settings, a password must be provided. By default, the
password is
pass
. When all parameters are set, the command
SAVE
is
used to store the parameters permanently. The command
%CONFIG-
leaves the configuration mode and resumes normal printing. The
syntax for the file to print is:
In order to maintain backward compatibility and increase security,
many parameters that are not related to the IBM printing operation
have to be preceded by the
%CONFIG++
command. When all
parameters are set, enter
%CONFIG--
. The parameters requiring
%CONFIG++
are clearly marked in the parameter listing on the
following pages.
%CONFIG+ <password;>
IBM_PRINTING_PARAMETER_NAME = VALUE;
SAVE;
%CONFIG-
%CONFIG+ <password;>
IBM_PRINTING_PARAMETER_NAME = VALUE;
%CONFIG++
PARAMETER_NAME = VALUE;
%CONFIG--
SAVE;
%CONFIG-