User`s manual

Appendix A: The Test Button
132 AXIS 570/670 MIO User’s Manual
AXIS 570/
670 MIO
Factory Default
Settings
To reset the AXIS 570/670 MIO to the factory default settings:
1. Switch off the printer.
2. Press and hold the Test button, then switch on the printer. Keep
the Test button pressed for at least 20 seconds after restoring
power to the printer until the Network indicator flashes at one
second intervals.
3. Release the Test button and wait at least five seconds (five
indicator flashes).
4. Press and hold the Test button again for at least five seconds until
the Network indicator remains constantly lit.
The AXIS 570/670 MIO is now reset to factory default settings.
Restart the AXIS 570/670 MIO by switching the printer off and on.
Note:
❏ The Node address parameter
NODE_ADDR
will remain unchanged,
but all other parameters are reset. Should you wish to change the
Node address, you may do so via the General Property page, using
AXIS NetPilot™.