User`s manual

Appendix C: The Front Panel
82 AXIS AX-3 Cobra+ User’s Manual
0
9
8
7
6
5
4
3
2
1
Select IBM Printer
Emulation
You can select IBM Printer Emulation by using the rotary switch.
This section applies to the IBM 4214 emulation only. Proceed as
follows:
1. Switch the AX-3 Cobra+ off. Note the current device address.
2. Select the position ‘8’ on the rotary switch.
3. Switch the AX-3 Cobra+ on. A printed message indicates the
current IBM Printer Emulation.
4. Press the printer’s ONLINE/OFFLINE key twice to change
emulation. The new emulation is confirmed by a printed message.
Repeat until the required emulation mode is achieved. Refer to
the list on page 9
5. Switch the AX-3 Cobra+ off to save the current emulation.
6. Set the device address and switch the AX-3 Cobra+ on for normal
print operation.