User`s manual

Section 3: Configuration
AXIS AX-3 Cobra+ User’s Manual 27
Exit the Configuration
Select ‘Exit’ in the Main Menu.
The following submenu is shown:
Select ‘Yes’ to exit the Configuration.
The Configuration Utility is terminated and the screen is left blank.
Disconnect the terminal and connect the AX-3 Cobra+ to your IBM
system.
If you select ‘No’ in this submenu the Main Menu will be displayed
again.
Note:
❏ If you exit without saving, the changes you have made to the
configuration will be lost at the next power-off.
====================================================
EXIT
====================================================
EXIT CONFIGURATION
_YES
NO
Please remember to set the Device Address on the
Rotary Switch! Power off before connecting to the
system.
Use <Up><Down> to move, <Enter> to select