User`s manual

Section 3: Configuration
18 AXIS AX-3 Cobra+ User’s Manual
Configuration from a Terminal
The AX-3 Cobra+ is equipped with a menu-driven Configuration
Utility. This provides a step-by-step method to adapt the AX-3
Cobra+ to your IBM host and printer. Follow these steps to start the
configuration:
1. Switch off the AX-3 Cobra+. If the power is taken from an
attached printer, then switch the printer off. If you are using an
external power supply, unplug the power cord.
2. Connect a terminal to the AX-3 Cobra+ using the Axis T-cable,
and switch the terminal on. The terminal should be terminated.
3. Set the rotary switch in position ‘7’ and switch the AX-3 Cobra+
on. Wait a few seconds until the SYSTEM indicator has stopped
flashing.
4. Select position ‘9’. Wait until the SYSTEM indicator starts to
flash.
5. Select position ‘7’.
Within a few seconds, the Key Definitions Menu should appear on
your terminal.
If you want to restart the configuration, just switch the AX-3 Cobra+
off and repeat from step 3.
The rest of this section is a guide to the Configuration Utility.