User`s manual

Section 3: Configuration
AXIS AX-3 Cobra+ User’s Manual 17
Section 3 Configuration
Although the AX-3 Cobra+ is prepared for operation at delivery, you
may want to alter the configuration. A test printout will verify the
current configuration, see page 12.
The configuration can be done in two ways:
• Configuration from a Terminal
This method is described in this section. The configuration
method requires a dedicated IBM 5250 terminal such as a 3180,
3179, 3197, 347x or 348x.
Alternatively a PC equipped with a 5250 terminal emulation
board or an Axis EMMA board (part no: 0041-1) can be used.
• Configuration from the System
The AX-3 Cobra+ can also be configured using down-loaded
programming sequences from the system, see page 33.