User`s manual

Section 2: Basic Installation
AXIS AX-3 Cobra+ User’s Manual 15
Change Emulation Laser/Matrix
The factory default emulation of the AX-3 Cobra+ is IBM 3812/5219
laser printer. You can easily change the emulation to IBM 4214 matrix
printer on the DIP switch inside the AX-3 Cobra+.
The AX-3 Cobra+ must be switched off and disconnected from the
System, the printer and the power supply.
Caution
❏ The AX-3 Cobra+ circuit board is static-sensitive. Mishandling
may cause permanent damage to its components. Make sure to
take all recommended precautions related to static-sensitive
devices. Use a non-metallic tool to adjust the switches
1. Unscrew the two screws on the back panel.
2. Gently pull the back panel. The attached circuit board with the
DIP switch will slide out of the box.
AX-3 Cobra+ DIP Switches
1
2
3
4
5
off
off
3812/5219
6
on
on
4214
on