User`s manual

Section 2: Basic Installation
AXIS AX-3 Cobra+ User’s Manual 13
The AX-3 Cobra+ will produce a test printout on the printer which
shows the firmware revision and basic configuration. The default
configuration is for an HP LaserJet II/III printer.
Example:
Test the printout in IBM 4214 emulation, see page 15.
The default configuration will support HP LaserJet II/III printers. If
you want to change the configuration, you can do this later when the
AX-3 Cobra+ has been installed towards the host. You can also alter
the standard configuration before continuing with system attachment
see page 14.
The test printout will show if the AX-3 Cobra+ has been configured
for your printer by the dealer/distributor.
Example:
The printout below shows that this AX-3 Cobra+ has been configured
for a Canon LBP-8III printer:
******** TEST PRINTOUT ********
AX-3 Cobra+ 3812/5219 Ver 5.23 960311
Printer Driver: #70 HP LaserJet II/III
IBM Printer Emulation____ IBM 3812/5219
System Language__________ International Set 5
ASCII Char. Set__________ Roman-8
******** TEST PRINTOUT ********
AX-3 Cobra+ 3812/5219 Ver 5.23 960311
Printer Driver: #72 Canon LBP-8III
IBM Printer Emulation____ IBM 3812/5219
System Language__________ International Set 5
ASCII Char. Set__________ PC-850