Specifications

www.baldormotion.com
5-20 Operation MN1941
4. If you are going to use
the relay , drag the
OUT12icon(therelay
output) to the grey
Drive Enable OP icon
on the right of the
screen.
To configure multiple axes to use the relay output, repeat this step for the other axes.
If you are going to use
a digital output, drag
the bright blue OUT
icon to the grey Drive
Enable OP axis icon on
the right of the screen.
To configure multiple
axes with the same drive enable output, repeat this step for the other axes.
5. Click Apply at the bottom of the screen. This
sends the output configuration to the
NextMove e100.