User`s manual

User’s Manual

< Step 5 > When the window searching the dynamixel appears, press the ‘Search’ button.

Step 6 > the ‘OK’ button is pressed after the dynamixel

is searched.

If the ‘Search’ cannot be implemented, redo ‘Search’ after cheching the following:

n the USB2Dynamixel and the dynamixel

and the status of power supply.

4. Quick Search is only possible when the Baud rate of the dynamixel is set to the main

Baud rate. When the user has changed the Baud rate of the dynamixel arbitrarily, do

not use the Full Search function.

1. Check whether the port is selected correctly.

2. Check whether the function selection switch of the USB2Dynamixel is located correctly.

3. Check the status of the connection betwee

Dynamixel Manager will be implemented when