Manual
-4-
-5-
1
3
7
Machine operation
Turn the flywheel 1 drawing the
carriage 3 (towards the operator);
Pull up the product grip 7;
6
Place the product to be sliced on
the tray 6;
9
7
12
1
4
14
5
Lower the product grip 7 to hold
the product;
Lower the lever 5 and move it to
draw the product near the blade
9;
Drawing the product near the
blade or away can be carried out
more precisely using the knob
14;
Set up the slice thickness
desired by operating the
graduated knob 4 (0รท2 mm);
Turn the flywheel 1 to start
slicing and placing the slides on
the tray 12.
3
1
6
5
15
Remove the product from the
tray 6;
Turn the flywheel 1 by drawing
the carriage 3 near the
operator;
Press the lever 5 down and at
the same time to the right;
Unscrew the locking knob 15
as shown in the image;
Cleaning the machine
Warning:
Always wear non-
scratch and anti-skid protection
gloves when carrying out the
operations described above.
Always operate with great care
and avoid any distraction.
DANGER OF CUTS!