Manual

2.1 – Technical Instructions for Gas Connections
Initial installation and operation of the appliance must be carried out by an Authorized
Service in compliance with technical requirements and local directives related to gas
connections.
All gas connections of the appliance must comply with ISO 7 – 1 or ISO 228 – 1
standard.
2.2 – Installation of the Appliance
The appliance must be installed on a stable, even and balanced ground made of stainless
steel. This stainless steel surface must be in a form preventing fat from flowing down from the
surface and spilling The appliance should never be installed on a plastic or wooden surface. It
must be installed so that at least 20 cm distance is maintained between the appliance and the
wall, during its use.
Gas connections of the döner-grillmachine must be done in compliance with the regulations in
force.
2.3 – Technical Specifications
The manufacturer reserves the rights to alter design and specifications without notice
AN ELECTRICAL AND GAS INSTALLATION COMPLYING WITH THE RELEVANT
LOCAL REGULATIONS MUST BE PRESENT AT THE FACILITY, BUILDING AND SIMILAR SITE
WHERE THE DÖNER-GRILLMACHINE WILL BE INSTALLED; NECESSARY PRECAUTIONS
MUST ALSO BE TAKEN TO ENSURE HEALTH AND MATERIAL SAFETY.
OTHERWISE OUR COMPANY WILL NOT BE RESPONSIBLE FOR THE
CONSEQUENCES.
!
The appliance should be operated under well ventilated conditions. The ventilation
system must be of non-flammable character, and the ventilation funnel must be free
of any obstruction.
!
Power supply cords and gas connection hoses of the appliance installed by
the Authorized Service must not be extended and changed.
!
2 – INSTALLATION INSTRUCTONS